Fujikura 22S Fiber Optical Fusion Splicer Active Alignment

Kit consists of: 1 unit 22S .Máquina fully automatic fusion splicing high performance and a single fiber, single mode and multimode valid. Alignment in all three axes. Easy to drive. Especially for work at heights, the lightest on the market. Weight 1140g (with battery). Incorporado.Dimensiones heater 120x189x72 mm. 2 years warranty.
ADC-19 and ACC-15.

Kit includes:

• 1 set of electrodes (ELCT2-12).
• 1 Power cord.
• 1 unit of Battery (BTR-11).
• 1 unit CT-06: Accuracy cutter.
• 1 rigid carrying case.

Specifications

• Applicable fibers Single / SMF (G.652/657), MMF (G.651), DSF (G.653), NZDSF (G.655)
• Cladding dia. / Sheath dia. 125 μm / 100μm to 3mm with sheath clamp
• Cleave length 5mm to 16mm
• Splice mode / heating mode Total 100 splice modes / 30 heating modes
• Typical splice loss 0.03dB (SM), 0.01dB (MM), 0.05dB (DS) and 0.05dB (NZDS)
• Measured by cut-back method relevant to ITU-T and IEC standards.
• Splice time / tube heating time Typical 7sec with SM / Typical 30sec with FP-03 (60mm) sleeve
• Splice result storage Last 2000 splices
• Viewing methods / magnification 2 axis 2CMOS camera with 4.73” color LCD. 132X magnification.200X magnification after splicing
• Tension test 1.96 to 2.25N
• Applicable protection sleeve 60mm, 40mm and Fujikura micro sleeves
• No. of splice / heating per battery full charge * 1 Typical 200 cycles with BTR-11
• Electrode life 3000 splices
• Size / weight 120W x 189D x 72H mm / 1140g (including battery)
• Operating condition Altitude : 0 to 3,660m above sea level, Wind : 15m/sec
• Temperature : -10 to 50deg C, Hμmidity : 0 to 95%RH, non-dew
• Other features PC software upgrade / data management
• Resistance features * 2 Shock resistance : 76cm (30inch) bottom surface drop
• Dust resistance : Exposure to dust (0.1 to 500μm dia. Alumina Silicate).
• Rain resistance : H=10mm/hr for 10min