Single phase protection for indoor installation of power supply lines.

Its small size allows it to be located next to the current outlets that will be used by users. It contains an effective protection for electric-pho-electrical supply lines. Fine protection according to the cascade protection recommended in the Low Voltage Regulation (REBT ITC23). Type 3 protection according to the UNE-EN 61643-11 standard and the GUBABT-23 of the REBT. Suitable for equipment of Categories I, II, III and IV according to ITC-BT-23 of the REBT.

Features

• Short response time
• They do not produce deflagration.
• They do not produce interruption of the supply lines at any time.
• Modular protection of small size.
• Thermodynamic control device and audible warning.
• Coordinated with the protectors of the ATSHOCK, ATSHIELD, ATSUB and ATCOVER series.

Installation

They are installed in parallel with the low voltage line, with connections to the phase, to the neutral and to earth.

The installation must be done without voltage on the line. It is recommended to be used in installations where equipment sensitive to transient overvoltages (computers, printers, servers, etc.) can be installed, always coordinated with protectors of type 1 or 2 in the previous panel.

The connection to earth is essential. In order for the protection to be correct, the ground connections of the entire installation must be connected directly or through sparks, and its resistance must be less than 10Ω. If the instructions in this file are not used or used, the protection guaranteed by This team can be compromised.

Specifications

CE, RoHS