Tower series 180 SE upper section of 2.5m built with stainless steel RPR. Maximum height is 7.5 m, including 3m mast. Televes 3015
Warning: Last items in stock!
Upper section constructed in steel, to which a "zincado brillante + bichromate" base treatment is applied, they are used in two types of finishes (RPR or polyester paint). They currently allow installation at heights from 1 to 50.5 m.
Depending on the model, they implement threaded or plug-in fittings (SE finish) for their union.
The series 180SE, allows to cover the most basic needs of catchment with its recessed sections. The maximum height is 7.5 m, including 3m mast.
Fixing the lower section to the base in the proper vertical position, and then mounting the consecutive intermediate sections, which will be fixed with the corresponding guy-wire; the assembly is carried out by climbing the already placed sections and raising subsequently the section to be placed, using for it the adequate elevating tools.
The climbing has to be made with the appropiate safety conditions (safety-belt, anchoring, etc.); there won’t be more than two sections without shoring up. In case of coinciding two sections without guy-wire, auxiliary guy-wire will be used for the bracing of the sections during the set-up. The tower will be balanced adjusting the tension of the guy-wire and the using of proper balance-appliances.
First assembling the tower over the ground and raising it, once mounted, by means of a crane. This system can be used only with towers of heights lower than
18 meters in the model 180 and heights lower than 26 meters in the model 360.
If the installation of the tower is made on the roof, flat roof or other place of a building, the installer will take the necessary measures according to the indications of the architect responsible of the building, in order to know the mechanical resistance of these zones.
|Main steel pipes||20x1.5|
|Transversal stainless steel rods||mm||6|
|Max. height with mast 3m||m||7.5|
No customer reviews for the moment.
Floor support Ø60 mm / L = 850 mm for 110-120cm antenna
Fixed column for 240cm antenna Ø 165x5x1500mm with base of 500x500x6mm
Floor support 60 x 2.0 x 850 mm for Gibertini antennas of 125 cm
This Tecatel steel bracket for high resistance floor diameter 100 mm / Length 1000 mm